Warning sign checklist that your roof needs attention.
Keep in mind when faced with a choice between roof repair vs. replacement, you need to factor in the age of the roof and the level of damage; inside and out.
Braymar has the products and the expertise to identify, fix, or replace shingles that can compromise the integrity of your roof.
BARE SPOTS
The protective granular surface of shingles wears off as the asphalt, into which the granules are embedded, begins to harden over time. Bare spots are often accompanied by fine fissures on the shingles’ surface and by the accumulation of granules in the gutters.
Clawing
This is the curling under of the shingle tab’s bottom edge and is part of the normal aging process of shingles. The bulge created is susceptible to substantial damage by wind action, hail and ice.
Curling
The upward curling of shingle tabs makes them highly susceptible to wind and ice damage. This is a problem on older roofs where moisture build-up in the attic affects the underside of the shingle.
Broken Shingles
Damage can be caused by extreme wind conditions and snow removal. Broken, torn or missing tabs become obvious entry points for water, especially on low slope roofs where run-off is slower & at the peaks of the roof where shingles are the most vulnerable to high winds.
Buckling
Buckling is a visible distortion or waviness in the horizontal lines of shingles and usually runs in a straight line up the roof slope. Shingle tabs become exposed to wind and can be torn off. The problem is often warping in the roof deck caused by poor attic ventilation. The use of thinner-than-recommended plywoods and other non-plywood materials adds to the problem.
Flashing
Many problems occur at the flashings around vents, plumbing stacks, chimneys and vertical wall joints. Is the flashing cracked? Is the caulking around the flashing dried out? Are the shingles that lie over the flashing in good shape?